Futaba GV-1 Manual de usuario descargar pdf (Pagina 17)

1919

ASSEMBLY & ADJUSTMENT

3Tighten the sensor stay together with the engine

mounting flange. (Temporary assembly)

4Select the mounting method so that the sensor

does not touch the frame, or other parts of the he-

licopter. Temporarily mount the sensor and select

the magnet mounting position.

-Install the sensor to the sensor stay using the accessory screws and wash-

ers.

-Tighten the sensor stay together with the engine using the engine mount

screw.

Cement the magnet to the cooling fan

so that the magnet is level with this side

of the cooling fan.

Magnet

Magnet mounting

(Cooling fan modification)

1Drill a hole in the fan at the magnet mounting posi-

tion.

Make the hole about 4.1mm in diameter and 1.5 to 1.7mm deep.

2Embed the magnet in this hole in the direction in

which an output is obtained.

Use epoxy adhesive that cures in 30 minutes or longer.

Do not use epoxies that contain metal such as JB Weld.

If the cooling fan is unbalanced and vibrates, etc., balance it by mounting

the spare magnet to the opposite side of the cooling fan in the opposite

polarity (so that it does not output a signal).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 48 49

Sin comentarios

Futaba GV-1 Manual de usuario Pagina 17