Futaba FBC-I Charger Manual de usuario descargar pdf

Futaba

TRANSMITTER/RECEIVER USE

NICKEL-CADMIUM BATTERY CHARGER

NT-8C(B)

NT-1

NR-4G

NR-4H

FBC-

9.6V 500mAH Transmitter use nickel-cadmium battery.

[FP-3E, 4E, other transmitters using 7 penlight

batteries]

12V 500mAH transmitter use nickel-cadmium battery.

[FP-3, 4, FP-2D, 3D, 4D use. cannot be used with E]

4.8V 500mAH receiver, servo use nickel cadmium battery.

4.8V 250mAH receiver, servo use small nickel-cadmium

battery

4.8V 500mAH receiver, servo use nickel cadmium battery.

NR-4C (NR-4G) Charger

NT-8C(B)

(NT-10)

and

NR-4C (NR-4G)

Charger

(With 2 charging cords)

NR-4C

—————

FBC-I

USAGE METHOD

—————

Connect the charger and nickel-cadmium

battery as shown in the figure.

A red LED will be lighted to indicate that

the battery is being charged.

Be sure that the polarity of the 3P Connector

is correct.

Charging time is 12-15 hours before use.

When not used for an extended period of time,

charge for about 20 hours before using.

Also recharge after more than one week has

elapsed since the last charging.

When completely charged, the battery can

normally be used 8-10 times at about 10

minutes use per time.

AC-11

1 2

FUTABA CORPORATION 2

Indice de contenidos

Pagina 1

FutabaTRANSMITTER/RECEIVER USENICKEL-CADMIUM BATTERY CHARGERNT-8C(B)NT-1 0NR-4GNR-4HFBC- IFBC- I9.6V 500mAH Transmitter use nickel-cadmium battery.[FP

Pagina 2 - FUTABA CORPORATION

—————FBC-II USAGE METHOD —————Connect the charger and nickel-cadmiumbattery as shown in the figure.Connect "TX" to the NT-8C(B) or NT-10(tra

Comentarios a estos manuales

Sin comentarios

Futaba FBC-I Charger Manual de usuario

Busca en linea o descarga Manual de usuario para Hardware Futaba FBC-I Charger. Futaba FBC-I Charger User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Futaba FBC-I Charger