Futaba R7008SB Manual de usuario descargar pdf

Applicable systems: Futaba FASSTest-2.4GHz system

transmitter

R7008SB

FASSTest-2.4GHz Bidirectional Communication System

S.BUS2 / S.BUS Port and 8 Channels for Conventional System

Receiver

Compliance Information Statement

(for U.S.A.)

This device, trade name Futaba Corporation of America, model number

R7008SB, complies with part15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

that may cause undesired operation.

(3) This module meets the requirements for a mobile device that may be used

at separation distances of more than 20cm from human body.

To meet the RF exposure requirements of the FCC this device shall not be co-

located with another transmitting device.

The responsible party of this device compliance is:

Futaba Service Center

3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.

TEL (217)398-8970 or E-mail: [email protected] (Support)

R7008SB Specications

FASSTest-2.4GHz system(18CH/12CH mode)/S.BUS2 and S.BUS port

and 8 channels for conventional system receiver

• Dual antenna diversity

• Size: 0.98 x 1.86 x 0.56 in. (24.9 x 47.3 x 14.3 mm)

• Weight: 0.38 oz. (10.9g)

• Power requirement: 3.7V to 7.4V(Voltage range: 3.5 to 8.4V)

• Battery F/S Voltage: It sets up with a transmitter

• Extra Voltage port: 0

～

70V DC

* Be sure that when using ESCs regulated output the capacity of the ESC must

meet your usage condition.

Thank you for purchasing a Futaba R7008SB FASSTest-2.4GHz compatible receiver.

The R7008SB receiver features bi-directional communication

with a FASSTest Futaba transmitter using the S.Bus2 port. Using the S.Bus2 port an impressive array of telemetry sensors may be utilized. It also

includes both standard PWM output ports and S.Bus output ports.

LED Indication

Green Red Status

Off Solid No signal reception

Solid Off Receiving signals

Alternate blink Unrecoverable error (EEPROM, etc.)

(Antenna installation)

90˚

Please refer the table below for LED status vs

receiver's condition.

1M23N17454

S.BUS2

port

S.BUS port (8/SB）

(S.BUS2）

R7008SB

Terminal box

S.BUS Servo

S.BUS Gyro

HUB

Extra Voltage

Port

Link/Mode switch

Antenna

LED

Servo for conventional

system

Channel1 output

Channel8 output

Temperature

Sensor

RPM

Sensor

Voltage

Sensor

Voltage

Sensor

Altitude

Sensor

Altitude

Sensor

S.BUS2 Tool

Battery to 7/B

(It is not used for a link.)

＋

−

It connects with the

battery for power, etc.

External voltage input

cable of an option is

used. The voltage of

the battery can be

displayed with a

transmitter.

Usage precaution

•AnalogservoscannotbeusedwiththeR7008SBintheFASSTest

12CH mode.

•TheR7008SB receiver can onlybeused with FASSTest capable

transmitters.

•Don'tconnecttoExtraVoltagebeforeturningonareceiver.

󾛽

WARNING

󾛻

Changesormodicationnotexpresslyapprovedbythe

partyresponsibleforcompliancecouldvoidtheuser’s

authoritytooperatetheequipment.

󾛹

TheR7008SBreceivershouldbeprotectedfromvibration

byfoamrubber,Velcroorsimilarmountingmethods.

Protectfrommoisture.

󾛻

Keepawayfromconductivematerialstoavoidshortcir-

cuits.

Antenna installation precaution

󾛻

Donotcutorbundlethereceiverantennawire.

󾛻

Donotbendthecoaxialcable.Itcausesdamage.

󾛻

Theantennasmustbemountedinsuchawaytoassure

theyarestrainrelieved.

󾛹

Keeptheantennaasfarawayfromthemotor,ESCand

othernoisesourcesasyoupossiblycan.

󾛹

Besurethatthetwoantennasareplacedat90degreesto

eachother.

•TheR7008SBhastwoantennas.Inordertomaximizesignalreception

and promotesafe modeling Futaba has adopted adiversity antenna

system.ThisallowsthereceivertoobtainRFsignalsonbothantennas

andyproblem-free.

Antenna installation for carbon fuselage

󾛽

WARNING

󾛹

Youmustleave30mmatthetipoftheantennafullyex-

posed.Theexposedantennashouldbesecuredsothatit

cannotmovearoundorbackinsideofyouraircraft.

(Typical installation)

1 2

Indice de contenidos

Pagina 1 - Extra Voltage

Applicable systems: Futaba FASSTest-2.4GHz system transmitter R7008SBFASSTest-2.4GHz Bidirectional Communication SystemS.BUS2 / S.BUS Port and 8 Chann

Pagina 2 - FASSTest

What is S.BUS?Unlike conventional radio control systems, the S.BUS system uses data communication to transmit control signals from a receiver to a ser

Comentarios a estos manuales

Sin comentarios

Futaba R7008SB Manual de usuario

Busca en linea o descarga Manual de usuario para Accesorios de comunicación Futaba R7008SB. Futaba R7008SB User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales