Futaba 6FN Manual de usuario

FP-6FN 6ch. FP-5FN 5ch.FP-4FN 4ch. FP-3FN 3ch.

4. Since all the servos are manufactured to the same standards, any servo can be used for any purpose.5. The FP-S6L (reversible servo, red label) in t

FUTABA TRAINER SYSTEM•The NEW FUTABA PROPORTIONAL Transmitters FP-T4FN. FP-T5FN, and FP-T6FN are equipped with thenewly developed FUTABA Trainer Syste

4. When the trainer button of Tx1 is depressed,radio waves will be directly radiated fromTx1, but the control operation is shifted toTx2. Consequently

NICKEL-CADMIUM BATTERY AND CHARGING METHODS• The FP-T3FN, FP-T4FN, FP-T5FN, and FP-T6FN transmitters are each equipped with a built-in nickel-cadmiumb

ReceiverWHITENiCd BatteryCharging plugCharger (RX)The 3P red female connector of the switch harness is used to charge the NR-4C (receiver and servo us

1. The cord with the power plug at both ends is the Tx charging use cord. To charge the transmitter, connectthis cord to Tx of the charger and "A

3. The use of a servo tray is extremely convenient when installing the servos. The method of installation isillustrated in the figure. (Insert each co

4. After setting the push rod at each servo, operate each servo fully left and right at least once. If the rod catchesor sticks at this time, the serv

GUARANTEEYour NEW FUTABA Digital Proportional R/C system is guaranteed against de-fects in workmanship and material for 180 days from the date of purc

FACTORY REPAIR SERVICETo insure prompt service, please follow the instructions given below.1. Charge the batteries for at least 18 hours prior to ship

INDEXFeatures ...Composition and Specifications ...

FUTABA CORPORATION OF AMERICA630 CAROB STREET, COMPTON CALIFORNIA 90220 U.S.A.Phone: (213)537-9610 •FUTABA CORPORATIONTokyo Office: Daido Bldg. 3-1-6

FEATURES OF THE NEW FUTABA PROPORTIONALRADIO CONTROL SYSTEMTRANSMITTER (FP—T6FN. FP—T5FN. FP—T4FN, FP—T3FN)1. Since all Futaba New Proportional Models

4. The BA-606 monolithic 1C is a 9-pin single-end-line 1C incorporating 2 high output current (500mA) PNP tran-sistors, 2 NPN transistors, 4 diodes, a

• SPECIFICATIONS: (All specifications are subject to change without prior notice.)TRANSMITTEROperating system... CH1—4, 2-stick system, CH5 snap

TRANSMITTER HANDLING INSTRUCTIONSFP T6FN(forFP -6FN)6 CHANNELFP-T5FN(tor FP-5FN)5-CHANNELFP-T4FN(for FP 4FN)4-CHANNELFP-T3FN(for FP-3FN)3-CHANNELFig.

The controls on the front panel of the transmitter are shown inFig. 2. The manipulation of these controls should be thoroughlymastered.FP-T4FN (FP-T3F

1. The FP-3FN, FP-4FN, FP-5FN, FP-6FN each use a built-in nickel-cadmium battery (8/450 mAH) as the transmitterpower source.2. Mount the antenna secur

RECEIVER AND SERVO HANDLING INSTRUCTIONS1. The FP-R6F receiver employs an 8 bit 1C and has been especially designed for 6 channel use. (Combined 5chan