Futaba 6EXH Manual de usuario

INSTRUCTION MUNUALfor Futaba 6EXHP 6-channel,PCM/PPM(FM) selectableRadio control system for helicopter1M23N12008FUTZ8564 V1.0Futaba CorporationTechni

10PROGRAMMING THE 6EXHP RADIO Anytime you wish to view or change any of the current settings in the transmitter, the programming mode must first be en

11PULS Modulation select functionThe Modulation select function is used to select the PPM or PCM mode of transmission, to match the receiver being use

12Dual Rates / Exponential SettingsThe aileron, elevator and rudder dual rates on the 6EXHP are simultaneously activated by the dual rate switch. The

13correct throw. The pushrods should first be connected to the servo arms and control horns so that the correct, or near correct control surface throw

14N-TH Normal throttle curve function Used to set throttle curve for normal flight. 5-point throttle curve is utilized to best match the blade collec

153. Use SELECT key to select the desire curve point. Point 1 is shown initially which is throttles stick all the way downward (slow) position. Point

16REVO Pitch-rudder mixing functionThis mix adds rudder in conjunction with pitch. This helps compensate for rotation of the helicopter caused by th

17• Heading-Hold SMM: 21st Century gyro technology. Computer chip technology. Expensive, easier set up, higher durability. Significant decrease in tem

18SWSH Swashplate types selection & Swash AFRThis function can chose from two swashplate types. Swash AFR can be set, if you chose 3-S type1-S:

19F/S Fail Safe (PCM mode only)The Fail Safe function is used to prescribe what the PCM receiver will do in the event radio interference is received,

2INTRODUCTIONThank you for purchasing the Futaba 6EXHP digital proportional R/C helicopter system. If this is your first “computer” radio, rest assured

20

21OTHER 6EXHP FUNCTIONSTrainer function (student only)The T6EXHP trainer function lets you practice flying as student by connecting the T6EXHP to

22Changing the 6EXHP stick mode The transmitter may be operated in four different stick “modes” (1, 2, 3 & 4). The modes determine the fu

23FLIGHT PREPARATIONFlight preparation is to be done at the flying field.IMPORTANT: Your radio control system transmits a signal on a certain frequency.

MODEL DATA RECORDING SHEET (Make copies before using)Model name: Model No. 1• 2 • 3 • 4 • 5 • 6  

3Transmitter: T6EXHPT6EXHP Transmitter with 6-model memory.Transmitting on 35, 40, 41, or 72 MHz band.Operating system: 2-stick, 6-channel systemModul

4INTRODUCTION TO THE 6EXHP SYSTEMIMPORTANT!: Always turn on the transmitter first, then the receiver. When turning off the system, always turn off the

5Charging jack - Port for charging the transmitter batteries with the included battery charger. On-off switchOn/off switch DATA INPUT lever - Used to

6• After the servos are installed, operate each servo over its full travel and check that the pushrods and servo arms do not bind or contact each oth

7RECEIVER AND SERVO CONNECTIONS Connect the servos to the receiver to perform the functions indicated:ReceiveroutputchannelFunction1234567BAileronElev

8called “memory.” If, for example, only two flights are made each time you go flying, the batteries will not have “reached” very far down into their ful

9Model memory number and model nameThe Futaba T6EXHP stores model memories for six models. This means all the data (control throws, trims, end points,