Futaba 6D, 6DN Manual de usuario

New FUTABADIGITAL PROPORTIONALRADIO CONTROL

TO CHARGE TRANSMITTER BATTERIES1. One end of the charging cord should be plugged into "A" at the bottom of the Transmitter and the other end

3. When installing the Servo, the use ofthe Servo tray is very convenient. Thisis done according to the diagram.Please make sure each connector isplug

4. After setting the push rods on each Servo, using transmitter, actuate each Servo fully from left to right makingsure the rod will not hang-up on an

GUARANTEEYour NEW FUTABA Digital Proportional R/C system is guaranteedfor 180 days from date of purchase against all defects in materials orworkmanshi

OUT OF WARRANTY FACTORY REPAIR SERVICETo insure prompt service, please follow the instructions listed below.1. Charge batteries for at least 18 hours

INDEXFeatures... 1Specifications ...

FUTABA NEW PROPORTIONAL R/C FEATURESTRANSMITTER1. All Futaba New Proportional Models are designed and manufactured to the identical standards and spec

TRANSMITTER OPERATIONWith the FP-4DN, a two-stick control willoperate:1. Throttle2. Aileron3. Elevator4. RudderWith the FP-5DN, in addition to the abo

The front panel controls on the Transmitters are shown in the Diagram below and it is suggested that the manipu-lation of these controls be well maste

1. FP-4DN, FP-5DN, FP-6DN and FP-5 Transmitters are equipped with a built-in transformer-type charger formaximum safety and provided with 8/450 mAH Ni

HANDLING THE RECEIVER AND SERVOS1 . The FP-R6D receiver incorporates an 8Bit integrated circuit and is made into6-channel operation. The same inte-gra

6. Connectors are made as shown in the above diagram. Please make certain that each connector is fully pluggedin and that the Aileron section etc., an

NI-CAD BATTERIES AND RE-CHARGINGFP-4DN, FP-5DN, FP-6DN and FP-5 Transmitters are equipped with eight (8) pen-light type Ni-Cad batteries.For the Recei