Futaba 4YF 2.4GHz FHSS Manual de usuario

INSTRUCTION MANUALfor Futaba 4YF-2.4GHz4-channel, FHSSRadio control systemfor Airplanes1M23N11409Futaba CorporationTechnical updates available at: htt

10RADIO INSTALLATIONFollow these guidelines to properly mount the servos, receiver and battery. • Make certain the alignment tab on the battery, swi

114YF-2.4GHz FUNCTIONSServo ReversingThe servo reverse switches are used to change the direction that a servo responds to a control input from the tra

12OTHER FUNCTIONSTrainer Function (Student only)The T4YF-2.4GHz trainer function lets you practice flying as a student by connecting the T4YF-2.4GHz to

13FLIGHT PREPARATIONFlight preparation is to be done at the flying field.If you are an inexperienced pilot, be certain your flight instructor performs th

14FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT (for U.S.A.)This equipment has been tested and found to comply with the limits for a Class

15©Copyright 2009. No part of this manual may be reproduced in any form without prior permission. The contents of this manual are subject to change

2TABLE OF CONTENTSIntroduction ...2Service ...

3Meaning of Special Markings Pay special attention to safety where indicated by the following marks: ｎDANGER - Procedures which may lead to dangerou

4FLYING SAFETY ｎWARNINGTo ensure the safety of yourself and others, please observe the following precautions: ｊ Have regular maintenance performed. Th

5If you do not turn on your system in this order, you may damage your servos or control surfaces, flood your engine, or in the case if electric-powered

6Transmitter: T4YF-2.4GT4YF-2.4GHz Transmitter of FHSS systemTransmitting on 2.4GHz bandOperating system: 2-stick, 4-channel systemPower supply: 6V (4

7INTRODUCTION TO THE 4YF-2.4GHz SYSTEMIMPORTANT!: Always turn on the transmitter first, then the receiver. When turning off the system, always turn of

8BATTERY REPLACEMENT METHOD (4 AA SIZE BATTERIES)1. Remove the battery cover from the transmitter by sliding it in the direction of the arrow in the fi

9LINK PROCEDUREEach transmitter has an individually assigned, unique ID code. In order to start operation, the receiver must be linked with the ID cod