• No part of this manual may be reproduced in any form without prior permission.
• The contents of this manual are subject to change without prior notice.
• This manual has been carefully written. Please write to Futaba if you feel that any corrections
or clarications should be made.
Before using your new 2.4GHz system, please read this manual thoroughly and use the
system properly and safely. After reading this manual, store it in a safe place.
1M23N17303
Contents and Technical Specications
Your 2.4GHz system includes the following components;
Installing the PK-FSM2.4G/R603FS
[Specication]
• Communication method: One-way operation system
• Mode: PPM, HRS (Auto-detect)
• Maximum operating range: 80m (Optimum condition)
• For safety: F/S, B-F/S, ID (About 4billion ways of pair identi-
cations)
PK-FSM2.4G;
• Transmission antenna: 1/2λ mono-pole
R603FS;
• Reception antenna: Diversity type (Two antennas: internal
and external)
• Power requirement: 6V Nicd battery
• DSC function available
• RS232C port: (for factory use only)
• Size: 39x26x14mm (excluding a projection part)
• Weight: 14.1g
PK-FSM2.4G Module
2.4GHz System
PK-FSM2.4G Module and
R603FS Receiver
Thank you for purchasing a PK-FSM2.4G module and an R603FS receiver. This system is
based on the combination of the newly developed 2.4GHz module and its correspondent
receiver. The system utilizes the 2.4GHz-SS radio communication and an ultra small antenna.
In addition, the system inherits Futaba's unique HRS (High Response System).
Features
2.4GHzSS (Spread Spectrum) radio communication system
Frequency channel setting unnecessary: Sifting the channels within the 2.4GHz band
automatically, this system minimizes the interference from other 2.4GHz system.
Accepts no unwanted signals by using ID code
The function “Auto-Detect” is utilized to automatically determine which mode is active,
HRS or PPM mode. (R603FS)
Short and small antenna (PK-FSM2.4G)/Diversity antenna (R603FS)
•
•
•
•
•
Applicable system; T3PK or T3VC Transmitter
R603FS Receiver
Module Cover for T3PK
Mini screwdriver
Install and adjust the PK-FSM2.4G module and R603FS receiver as described below.
Attachment of the module
CAUTION
Be sure to turn off the power of the transmitter before you attach
or detach the module.
1
Insert the module with care so that the connector pins of the
transmitter won't be bent.
WARNING
Adjust the antenna vertically to the ground. Otherwise, the oper-
ating range may become shorter.
T3PK Transmitter
PK-FSM2.4G Module
Antenna
Module Cover
T3VC Transmitter
PK-FSM2.4G Module
Antenna
0
1
2
3
4
5
6
7
8
9
(Antenna Moving Range)
I
NSTRUCTION
M
ANUAL
For cars only
Comentarios a estos manuales